No concrete, no curing
Wind the screw in and fix the light. It can be wired and switched on the same day.
A ground-screw kit for garden bollards and pillar lights — for lighting brands, electrical and lighting wholesalers and installers. No digging out, no concrete, no curing: the light can be wired the same day.
Wind the screw in and fix the light. It can be wired and switched on the same day.
Openings in the screw let the supply cable run inside the foundation, out of sight and protected.
Goes in without digging up the planting or lifting turf around the light.
Wind the screw in or out until the plate sits level at the right height.
Lights can be moved later. There is no concrete to break out.

Set 240350K has everything needed to set four garden lights. Once the luminaires are chosen, there is nothing else to buy.
Set 240350K – product page →Single screw 240350 – product page →
Most small garden bollards and pillar lights fix with three bolts on a bolt circle of roughly 60–100 mm. The holes are drilled on site into the 120 mm plate (drill bits are in the kit), so one foundation suits many fittings.
It is made for garden-scale lights. It is not intended for commercial bollards with large base plates, or for posts taller than about 1 m.
It works with 12 V and 230 V fittings: the foundation is passive steel. Wiring must follow local rules and be done by a qualified electrician where required.
Not sure about a fitting? Add its base dimensions to your sample request.
Add the Fastshifter kit as an accessory to your garden lights: one foundation that suits many of your fittings.
A ready-made foundation kit for the installers who already buy garden lighting from you.
For landscapers who set path and bed lighting alongside paving and planting.
A practical add-on to a garden light, with product data and photos ready to list.
Mark the light position and bring the supply cable to it.
Drive the screw in by hand with the turning bar, with the cable running inside the foundation.
Wind in or out until the plate is level, just above the finished ground.
Drill the light’s fixing holes into the plate and fix it with the self-tapping screws.
Most small garden bollards and pillar lights with three bolts on a bolt circle of about 60–100 mm fit: the holes are drilled on site into the 120 mm plate. It is not meant for commercial bollards with large base plates or posts taller than about 1 m.
Yes. The foundation is passive steel and the cable runs inside it. Wiring must follow local rules and be done by a qualified electrician where required.
Prices are not published on the website. Ask for the price list with the form below and we will send it for your market.
Yes. Tick “Please send me product samples” in the form and we will arrange a sample kit, so you can try it with your own fittings.
Tell us about your company and your lighting range. It takes two minutes.